Martin® Brush Cleaner is a motorised, rotating specialty belt cleaner engineered for belts that carry raised elements such as cleats, chevrons, ribs or lugs, where a standard blade cleaner cannot maintain consistent contact. A one or two-horsepower, 230/460-volt three-phase electric motor turns the brush against the direction of belt travel, dislodging fines and residue trapped in the belt's profile. The Martin® Spiral Brush Cleaner uses 0.038 inch (0.96 mm) polypropylene bristles wrapped in a spiral around the hub, while the Martin® Strip Brush Cleaner uses 12 brush strips that shed even moist material that would plug other brush designs. Used for:

• Removing fines and residue from ribbed, flighted, grooved or chevron conveyor belts
• Light to medium duty secondary cleaning where blade-type cleaners are unsuitable
• Sticky materials or stringy fibers such as coal and biomass
• Coal, biomass, food processing, packaging and other specialty carryback applications

Recommended installation is in the secondary cleaning position where the belt leaves the discharge pulley, or further along the return run supported by an idler or pulley. Accommodates a maximum 3/8" cleat height.

• Ribbed, flighted, grooved or chevron conveyor belts
• Coal, biomass and other sticky or stringy materials
• Cement, feed, foundry sand, coke and similar dry materials
• Food processing and packaging conveyor lines
• Light to medium duty carryback removal on cleated belts
• Underground applications requiring mechanical splice clearance

• Genuine Martin Engineering product, supplied by an authorised distributor
• Economical 1 HP or 2 HP electric motor, depending on belt width, for efficient operation
• Spiral or strip brush configurations to suit dry or moist material conditions
• Effective on ribbed, flighted, grooved and chevron belt profiles
• Accommodates mechanical splices without damage
• Available with polypropylene, oil-tempered wire or nylon brushes